HLP 6000 DSTS IR paint dryer


The 6000 DSTS model has six 1kW Glare control lamps, fitted into three twin cassettes.

Temperature is controlled through an optical electronic digital feedback loop which turns the heat up and down as required during the cycle.

The unit is equipped with a digital distance readout allowing it to be correctly positioned.

Lamps emit shortwave infrared heat ideal for optimizing drying of water based paints.

This flexible system allows the cassettes to be adjusted and locked into position around the contours of the vehicle body, ensuring maximum area coverage.

Height adjustment is made using the high performance locking gas strut, offering a near weightless movement to the cassette support arm.



Area coverage : 2000mm x 1000mm

Minimum operating distance : 600mm

Maximum vertical curing height : 2030mm

Maximum horizontal curing height : 1800mm

Maximum curing temperature : 80 deg C

Electrical : 220/240V, 6kW, 50Hz, single phase, 25 Amps.

      380/415V, 6kW, 50Hz, 3 phase, 8.33 Amps/phase

1kW high output glare control shortwave lamps fitted to each cassette, 500mm long

Specially designed electronic touch control panel allowing power, time and temperature control.

Twin 30 minute programmable timers on both the flash and bake settings.

Temperature settable on both flash and bake cycle.

Digital distance readout with safety cut off if the unit is moved too close.

Robust steel constructed frame fitted with rear wheel locking castors.

Maintenance free cassettes with no fan or filter changes.

Individually switched cassettes.

Horizontal or vertical cassette operation.

While operating, unit can display temperature or time remaining on flash or bake cycle.

Long lamp life with an average of 6000 hours.

Average curing time

Filler : 4-6 minutes

Primer : 6-8 minutes

Top coat : 10-12 minutes